Service manual

9. Install the exhaust cover. Tighten the 3 bolts to
the specifi ed torque.
Exhaust cover retaining bolt:
12 Nm (1.2 kgf-m, 8.7 ft-lb)
Loctite® 242
10. Tighten the screw clamp for the exhaust joint to
the specifi ed torque.
Exhaust joint – screw clamp:
2.5 Nm (0.25 kgf-m, 1.8 ft-lb)
11. Install the YPVS motor (only on models equipped
with YPVS).
YPVS motor:
5.4 Nm (0.54 kgf-m, 3.9 ft-lb)
12. Connect the cooling water temperature sensor
coupler and the exhaust temperature sensor
coupler.
13. Install the spark plug caps.
14. Connect the battery cables.
NOTE: Make sure the battery band is installed
securely.
15. Install the seat.
16. Start the engine, and use the multifunction
meter or YDIS to measure the trolling speed of
the engine.
Trolling speed:
1250~1450 r/min
17. To prevent the replaced throttle cable from
being reused inadvertently, break it with pliers to
render it unusable. Attach a warranty claim tag
and store it for 90 days.
18. When the modifi cation is complete, put a black
circle with permanent marker under the Primary
ID label as shown in Identifi cation Procedure.
PAGE 12 of 20