Service manual

VX1100
Refer to the VX1100 Service Manual
(LIT-18616-02-91), if necessary, when performing
these procedures.
1. Remove the seat and disconnect the battery
terminals.
2. Open the front hood, remove the 4 plastic rivets,
and remove the storage compartment panel.
NOTE: To remove a rivet, push the rivet pin until it
is below the top surface of the rivet and makes a
sound.
3. Disconnect the throttle cable from the accelera-
tor position sensor assembly.
4. Remove the upper handlebar cover; then, dis-
connect the throttle cable from the throttle
lever.
5. Remove the upper handlebar holders, and
place the handlebar assembly to the side.
To protect the watercraft from scratches, cover
the handlebar assembly with a clean cloth.
PAGE 13 of 20
CAUTION:
THROTTLE
CABLE
HANDLEBAR
HOLDERS
STORAGE
COMPARTMENT
PANEL