Service manual

6. Remove the grommet from the steering column,
and pull the throttle cable inboard.
NOTE: Do not reuse the grommet that has been
removed.
7. Replace the throttle cable with the new throttle
cable.
NOTE: Identify the throttle cable by its parts num-
ber.
8. Route the throttle cable from the corrugated
tube to the steering column.
9. Apply water resistant grease to the throttle
cable end. Connect the throttle cable to the
accelerator position sensor assembly. Before
doing so, measure the installation length “A” of
the throttle cable. Adjust it if this measurement
is out of specifi cation.
Throttle cable installation length “A”:
18.4±1 mm (0.72±0.04 in)
Throttle cable locknut:
6.5 Nm (0.65 kgf-m, 4.7 ft-lb)
Route the throttle cable above the main wiring
harness.
PAGE 14 of 20
CAUTION:
GROMMET
NEW: 6D31102
PREVIOUS: 6D31101
MAIN WIRING