Service manual

12. Connect the cable end to the throttle lever.
Then, adjust the throttle lever free play.
Throttle lever free play “A:”
4~7 mm (0.16~0.28 in)
After adjusting free play, turn the handlebar
side to side to make sure the free play does not
change.
NOTE: As shown in the illustration, install the seal
1 into the groove in the bracket. Pull the throttle
cable 2 in the direction of the arrow, and install
the seal end 3 around the inner cable. Turn the
adjuster 4 in or out until the specifi ed free play is
obtained. Tighten the locknut 5.
Make sure the accelerator position sensor assembly
cam comes in contact with both the fully open and
fully closed stoppers and makes a clicking sound.
Apply water resistant grease to the throttle cable
end.
PAGE 16 of 20
WARNING
a