Service manual

13. Install the pad.
NOTE: Before installing the long pad a, cut off
57.8mm (2.3 in) from its lower end, thus setting its
overall length to 139.4mm (5.5 in). Install the short
pad b as is.
14. Install the upper handlebar cover and the stor-
age compartment panel.
15. Connect the battery terminals and start the
engine. Use the multifunction meter or YDIS to
measure the trolling speed of the engine.
Trolling speed:
1550~1750 r/min
16. To prevent the replaced throttle cable from
being reused inadvertently, break it with pliers to
render it unusable. Attach a warranty claim tag
and store it for 90 days.
17. When the modifi cation is complete, put a black
circle with permanent marker under the Primary
ID label as shown in Identifi cation Procedure
PAGE 17 of 20
b
a