Service manual

Exhaust System Removal
1. Remove the seat and disconnect the battery.
2. Remove all the spark plug caps.
3. Disconnect the exhaust temperature sensor
coupler and the cooling water temperature sen-
sor coupler from the side of the box.
Be careful not to damage the couplers while
disconnecting them.
4. Loosen the exhaust joint screw clamp.
5. Remove the YPVS motor (only on models
equipped with YPVS).
6. Remove the 3 exhaust cover retaining bolts and
remove the exhaust cover.
NOTE:
During reassembly, replace the bolt covers and the
gasket on the underside of the exhaust cover with
the new ones in the kit.
7. Remove the cooling water pipe from the ex-
haust muffl er assembly.
CAUTION:
PAGE 3 of 20