Service manual

8. Remove the cooling water pipe from below
the outer exhaust joint and loosen the 2 screw
clamp.
9. Slide the outer exhaust joint forward. Then,
loosen the 1 screw clamp on the inner exhaust
joint, at the exhaust muffl er assembly side.
10. Remove the exhaust muffl er assembly as shown
in the illustration.
Be careful not to damage the watercraft while
removing the exhaust muffl er assembly.
11. Remove the 3 plastic ties on the inside of the
watercraft at the port side, and place the wiring
harness aside, inside the watercraft.
12. Remove the 4 cooling water pipes that are con-
nected to the exhaust chamber assembly.
PAGE 4 of 20
CAUTION:
2
1
4
1
2
3
5