User Manual
Table Of Contents
- VXL1-16P Remote Control Protocol Specifications
- 0. Revision History
- 1. Setup
- 2. Command List
- 3. Command Specifications
- 4. Command Sequence
- 5. Meter Value
- 6. Parameter Value Details
- 7. Parameter List
- 8. Meter List
VXL1-16P Remote Control Protocol Specications Version 1.2.0 rev2
5
1. Setup
1.1. Connection Procedure
Remote Controller
Network
Switch
Ethernet
VXL1-16P
Ethernet Dante conector
1.2. Conguring the Remote Controller
VXL1-16P can be controlled from an external controller through the Ethernet (Dante) connector
The conguration on the remote controller side for each type of connection is shown below.
Ethernet (NETWORK connector) control
IP Address: Specify the IP address of the VXL1-16P
IP Port No.: 49280
1.3. Device Conguration
The setting required on the main unit is the IP address (UNIT ID) setting.
Up to four remote controller devices can connect simultaneously to one VXL1-16P device.