User Manual

14
VXL1B-16P/VXL1W-16P Owner’s Manual
If you want to return (initialize) the internal memory to its factory-set
state, such as after changing the location of installation, proceed as
follows.
1
Turn off the PSE (Power Sourcing Equipment).
2
On the rear panel, set device setting DIP switch 7
downward and switch 8 upward (INITIALIZE).
3
Power‑on the PSE.
Initialization begins.
•During initialization:
The POWER indicator flashes rapidly.
•When initialization is complete:
The POWER indicator flashes slowly.
•If initialization fails:
The POWER indicator is unlit.
NOTICE
Do not power-off the PSE while initialization is in progress. This could
cause malfunctions.
4
Verify that initialization is complete, and power‑off
the PSE.
5
Set device setting DIP switches 7 and 8 both in
the upward (RESUME) position.
6
Power‑on the PSE.
The unit starts in the factory-set state.
Initialization