User Manual

13
VXL1B-16P/VXL1W-16P Owner’s Manual
Installing the speakers
3
Set the device setting DIP switches
3-1
On the rear panel, set the device setting DIP switches
(page 9) as appropriate for your installation.
NOTE
If you are connecting multiple VXL1B-16P or VXL1W-16P units
in the same network, set the UNIT ID so that the settings do not
overlap.
4
Connect to the Dante/NETWORK port
4-1
Connect an Ethernet cable (CAT5e or higher) from the PSE
(Power Sourcing Equipment) to the Dante/NETWORK port.
NOTE
Connect the Ethernet cable to the LAN port of the PSE (Power Sourcing
Equipment).
5
Attach the safety wire to the wall
CAUTION
Attach the safety wire above the speaker, and do not allow it to be slack.
6
Installing the main speaker unit onto the wall
6-1
Fit the bracket base together with the mounting bracket by
inserting from the top, making sure to insert the mounting
bracket all the way until the parts lock together.
NOTICE
•When installing the speaker, grasp it in the middle by its sides.
•Make sure that the mounting base and mounting bracket are locked
together in two places, top and bottom.
When removing, pick up the entire speaker while lightly pushing to the
left.
7
Make patch settings from Dante Controller
For details, refer to the Dante Controller user guide.
8
Power‑on the PSE