User Manual

VXL1B-16P/VXL1W-16P Owner’s Manual

Controls and Connectors

Setting method

Turn off the power of the PSE (Power Sourcing Equipment) before you

change these settings. Even if you change these settings while the

power is on, the change is not applied until the power is turned off.

For details, refer to the following.

DIP switch

Position

The DIP switch is in the upward position

DIP switch

Position

The DIP switch is in the downward position

DIP switches 1–4 (UNIT ID)

These specify the UNIT ID of the device. The UNIT ID is assigned as the

value specified by DIP switches 1–4 plus 100, producing a value in the

range of 101–115 (Hexadecimal 65–73). In the table below, “up” and

“down” indicate whether the DIP switch is in the upward or downward

position.

UNIT ID

DIP switch

1 2 3 4

101 down up up up

102 up down up up

103 down down up up

104 up up down up

105 down up down up

106 up down down up

107 down down down up

108 up up up down

109 down up up down

110 up down up down

111 down down up down

112 up up down down

113 down up down down

114 up down down down

115 down down down down

RESERVED up up up up

NOTE

If you are connecting multiple VXL1B-16P or VXL1W-16P units in the

same network, set the UNIT ID so that the settings do not overlap.