Service manual

6-5
IGNITION SYSTEM
2. Inspect:
• Charging coil 1 resistance
Out of specification → Replace.
3. Inspect:
• Charging coil 2 resistance
Out of specification → Replace.
CHECKING THE NEUTRAL
SWITCH
1. Inspect:
• Neutral switch conduction
Not conductive while it is in neutral →
Replace.
Conductive while it is engaged → Re-
place.
Set the tester selection position to "Ω
× 1".
CHECKING THE CDI UNIT
Check all electrical components. If no
fault is found, replace the CDI unit.
Then check the electrical compo-
nents again.
Tester (+) lead → Brown lead "1"
Tester (-) lead → Green lead "2"
Charging
coil 1 resis-
tance
Tester se-
lector posi-
tion
720-1,080
Ω at 20 °C
(68 °F)
Ω ×100
Tester (+) lead → Pink lead "1"
Tester (-) lead → Black lead "2"
Charging
coil 2 resis-
tance
Tester se-
lector posi-
tion
44-66 Ω at
20 °C (68
°F)
Ω ×10
B
WBr
G
P
R
B
WBr
G
P
R
Tester (+) lead→Sky blue lead "1"
Tester (-) lead → Ground "2"
Result
Conductive (while gear
is in neutral)