User Manual

CL Editor Owner’s Manual
17
1 Input patch
Click here to select the input source that will be assigned to the INPUT CH, from the fol-
lowing choices.
2 HA (HA analog gain)
Drag the knob in the screen to adjust the analog gain of the internal head amp or of the
external head amp patched to the INPUT CH.
3 48V (Phantom power)
Switches on/off the phantom power (+48V) of the internal head amp or of the external head
amp patched to the INPUT CH.
Wireless device indication
If a wireless digital system receiver is connected and patched to an input port as a I/O
device, the head amp indication changes to a wireless device indication.
In Diversity mode, the RF signal meter will indicate the level for both channels A and B.
In Quadversity mode, the meter will indicate only the highest level among channels A
through D.
Indication of a device that does not feature Dante outputs
If you connect a device that does not feature Dante outputs, such as Shure AXT400, QLXD4,
or ULXD4, and patch it to an input port, the head amp indication will change.
This indication varies depending on the type of the patched device.
(Example) Indication if Shure AXT400 is patched
When the receiver is on and connected via a ShowLink
®
remote control
When the receiver is on and not connected via a ShowLink
®
remote control
NONE No assignment
DANTE 1–DANTE 64 DANTE INPUT 1 – 64
OMNI 1–OMNI 8 OMNI IN jacks 1 – 8
PB OUT L, PB OUT R L/R outputs of PLAYBACK
SLOT1-1, SLOT1-2...SLOT3-15,
SLOT3-16
Input channels of an I/O card installed in slots 1–3
FX1L(A), FX1R(B)...FX8L(A), FX8R(B) L/R outputs of EFFECT rack 1 – 8
PR1L(A), PR1R(B), PR2L(A), PR2R(B) L/R outputs of PREMIUM rack 1 – 2
1
2
3
Gain level
RF (Radio Frequency) signal meter
MUTE indicator
Battery indicator
The RF level is shown for two channels (A and B).