User Manual

CL Editor Owner’s Manual
34
5 DIV (Divergence)
Adjusts the ratio of center-position signals distributed to the left, right and center channels. The current value is indi-
cated in the numerical box directly below this section.
6 LFE (Low Frequency Effect)
Adjusts the level of signals sent from the input channel to the LFE bus for the subwoofer. The current value is indicated
in the numerical box directly below this section.
Indication when using CUE B
In the ONLINE state, if MATRIX bus channels 7 and 8 can be used as a second cue, the MATRIX 7 and 8 send indication
will change to indicate that it is being used as CUE B.
❏ HA/D.GAIN/HPF/Ø/GC
1 HA (HA analog gain)
Adjusts the analog gain of the internal head amp or of the external
head amp patched to the input channel. The current value is shown
in the numerical box below the knob. You can set this to the default
value (– 6dB) by holding down the <Ctrl>(< >) key and clicking
the knob. You can also use the [48V] button to switch phantom
power on/off.
Wireless device indication
If a wireless digital system receiver is connected and patched to an input port as a I/O device, the head amp indication
changes to a wireless device indication.
Indication of a device that does not feature Dante outputs
If you connect a device that does not feature Dante outputs, such as Shure AXT400, QLXD4, or ULXD4, and patch it to
an input port, the head amp indication will change.
This indication varies depending on the type of the patched device.
(Example) Indication if Shure AXT400 is patched
When the receiver is on and connected via a ShowLink
®
remote control
54 6 7
132
Gain level
RF level
Mute status
Battery status
Channel name
Frequency
“TX.GAIN” is displayed.
The RF level is shown for two channels (A and B).