User Manual
Table Of Contents
- Getting Started
- Main window
- Overview window
- Selected Channel window
- Library window
- Premium Rack Library window
- Patch Editor window
- Virtual Rack window
- Meter window
- Group/Link window
- Scene window
- Custom Fader Bank Setup window
- Custom Fader Bank window
- User Defined Keys Setup window
- User Defined Knobs Setup window
- Sends On Fader window
- Outport Setup window
- Keyboard Shortcuts
- Index
CL Editor Owner’s Manual
49
A LOW shelving
If this button is on, the LOW EQ will be switched to a shelving type. If the EQ type is PRECISE, the Q knob of LOW EQ
adjusts the Q value of the shelving type EQ. For other EQ types, the Q knob of the LOW EQ is not shown.
B HPF (High Pass Filter)
If this button is on, the LOW EQ will function as a high pass filter EQ. The Q knob of the LOW EQ is not displayed,
and the GAIN knob acts as the high pass filter on/off switch.
C TYPE I/TYPE II
If the EQ type is LEGACY, you can choose one of two types: TYPE I or TYPE II.
D ATT (Attenuation)
Adjusts the amount of attenuation for the signal level of pre EQ.
❏ DYNAMICS1
Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S, and that
you can select more than one signal as the key-in signal, this is the same as the dynamics for input channels (➥ p.38.)
❏ INSERT
Except for the fact that the insert ports that can be selected are different, this is the same as for the insert settings of an
input channel (➥ p.43.)
❏ RECALL SAFE/MUTE SAFE
These are the same as the RECALL SAFE/MUTE SAFE functions for input channels (➥ p.44.)
❏ DCA GROUP/MUTE GROUP
These are the same as the DCA GROUP/MUTE GROUP functions for input channels (➥ p.45.)
❏ Fader
1 ON
Switches the MIX channel on/off.
2 Fader
Adjusts the output level of the MIX channel. A meter indicating the signal level is shown at
the right of the fader, and the current value is shown in the numerical box immediately
below. You can set this to the minimum value (–∞ dB) by holding down the <Ctrl>(< >)
key of your computer keyboard and clicking the fader knob, or set it to the nominal value
(0.00 dB) by holding down the <Ctrl>(< >) key and <Shift> key and clicking the fader
knob.
3 CUE
This button cue-monitors the signal of the MIX channel.
In the ONLINE state, if MATRIX bus channels 7 and 8 can be used as a second cue, the
indication shows “CUE A,” “CUE B,” or “CUE AB” depending on the settings of the console.
If the Channel Select/Sends On Fader checkbox in the System Setup dia-
log box is not checked, the [CUE] button will be hidden in the screen.
1
2
3
NOTE