User Manual

CL Editor Owner’s Manual
53
❏ BALANCE (except for MONO channel)
This adjusts the left/right volume balance in the STEREO bus. You can set this
to the center value by holding down the <Ctrl>(< >) key of your computer
keyboard and clicking this knob.
❏ EQ (Equalizer)
This is the same as the equalizer settings of a MIX channel (➥ p.48.)
❏ DYNAMICS1
Except for the fact that the available types are COMPRESSOR, EXPANDER, COMPAND H and COMPAND S, and that
you can select more than one signal as the key-in signal, this is the same as the dynamics for input channels (➥ p.38.)
❏ INSERT
Except for the fact that the insert ports that can be selected are different, this is the same as for the insert settings of an
input channel (➥ p.43.)
❏ RECALL SAFE/MUTE SAFE
These are the same as the RECALL SAFE/MUTE SAFE functions for input channels (➥ p.44.)
❏ DCA GROUP/MUTE GROUP
These are the same as the DCA GROUP/MUTE GROUP functions for input channels (➥ p.45.)
❏ Fader
1 ON
This switches the STEREO/MONO channel on/off.
2 Fader
Adjusts the output level of the STEREO/MONO channel. A
meter indicating the signal level is shown at the right of the
fader, and the current value is shown in the numerical box
immediately below.
3 CUE
This button cue-monitors the signal of the STEREO/MONO
channel.
In the ONLINE state, if MATRIX bus channels 7 and 8 can be
used as a second cue, the indication shows “CUE A,” “CUE B,” or
“CUE AB” depending on the settings of the console.
If the Channel Select/Sends On Fader checkbox
in the System Setup dialog box is not checked,
the [CUE] button will be hidden in the screen.
1
2
3
1
2
3
STEREO MONO
NOTE