User Manual

Table Of Contents

CL Editor Owner’s Manual

(*) CL3: 1–64, CL1: 1–48

The channel name is shown in the boxes immediately below.

0 Output meter

Indicates the level of the signal being output from the internal effect.

A Parameter display select button

If “REV-X HALL,” “REV-X ROOM,” “REV-X PLATE,” or VCM effect is selected as the effect type, this button switches

between the standard parameter screen and a dedicated GUI screen.

B MIX BALANCE

Adjusts the balance of the effect sound relative to the original sound. 0 (%) outputs only the

original sound, and 100 (%) outputs only the effect sound.

C TEMPO

If a tempo-type or modulation-type effect is selected, this allows you to adjust time-related

parameters such as DELAY (delay time) and FREQ. (modulation speed.)

To set the value of the TEMPO parameter, you can either input the BPM (Beats Per Minute)

in the numerical box, or repeatedly click the TAP TEMPO button at the desired tempo.

If the MIDI CLK button is on, the TEMPO parameter value will synchronize to the MIDI

timing clock being received from the MIDI port.

D SOLO

If “M.BAND DYNA” or “M.BAND COMP” are selected as the effect type, these buttons

allow you to monitor only the specified band from the three bands HIGH, MID, and LOW.

E GR meter (Gain Reduction meter)

If “M.BAND DYNA” or “M.BAND COMP” are selected as the effect type, this indicates the

gain reduction amount for the H (HIGH), M (MID), and L (LOW) bands.

INS1 CH 1–72(*) INPUT channel 1–72(*) insert in 1

INS1 MIX 1–24 MIX channel 1–24 insert in 1

INS1 MTRX1–8 MATRIX channel 1–8 insert in 1

INS1 ST L, INS1 ST R, INS1 M(C) Insert in 1 of STEREO channel L/R or the MONO channel

INS2 CH 1–72(*) INPUT channel 1–72(*) insert in 2

INS2 MIX 1–24 MIX channel 1–24 insert in 2

INS2 MTRX1–8 MATRIX channel 1–8 insert in 2

INS2 ST L, INS2 ST R, INS2 M(C) Insert in 2 of STEREO channel L/R or the MONO channel