User Manual

Notified Body
0359
Intertek Testing & Certification Limited
Cleeve Road, Leatherhead
Surrey, KT22 7SB
Tel: + 44 (0)1372 370900
Fax: [phone]
E-mail: [e-mail]
Daniel Griffin
Certification Manager
Date
Issue
19/12/2014
2
Re-Issue 07/11/2019
www.intertek.com
Registered No 3272281 Academy Place, 1-9 Brook Street, Brentwood, Essex,
CM14 5NQ, United Kingdom
This Certificate is for the exclusive use of Intertek's client and is provided pursuant to the agreement between Intertek and
its Client. Intertek's responsibility and
liability are limited to the terms and conditions of the agreement. Intertek assumes no liability to any party, other than to the C
lient in accordance with the
agreement, for any loss, expense or damage occasioned by the use of this Certificate. Only the Client
is authorized to permit copying or distribution of this
Certificate and then only in its entirety. Any use of the Intertek name or one of its marks for the sale or advertisement of the
tested material, product or service
must first be approved in writing by Intertek.
Page 1 of
3
Certificate of Constancy of Performance
0359-CPR-00406
In compliance with Regulation 305/2011/EU of the European Parliament and of the
Council of 9 March 2011 (the Construction Products Regulation), this certificate applies
to the construction product(s).
Product(s):
VX
S
Range of
Wall Mounted
Loudspeakers
(refer to attached appendix for details and conditions)
Produced by or for:
Yamaha Corporation
10-1, Nakazawa-cho, Naka-ku, Hamamatsu-shi, Shizuoka 430-8650, Japan
Produced in the
manufacturing plant(s):
P.T. Yamaha Ele
ctronics Manufacturing Indonesia (YAM
AHAID.01)
Kawasan Industri PIER (Kawasan Berikat Nusantara), Jalan Rembang Industri
II/9-11, Mojoparon-Rembang, Pasuruan 67152, Indonesia
Intended use:
Fire Safety
This certificate attests that all provisions concerning the assessment and
verification o
f constancy of performance described in Annex ZA of the
standard(s):
EN54-24:2008
Fire detection and fire alarm systems. Components of Voice Alarm
Systems - Loudspeakers
Under system 1 are applied and that the product(s) fulfils all the prescribed
requirements set out above.
This certificate was first issued on
7
th
November 2014
and will remain valid as
long as the test methods and/or factory production control requirements included
in the harmonised standard, used to assess the performance of the declare
d
characteristics, do not change, and the product, and the manufacturing conditions
in the plant are not modified significantly, unless suspended or withdrawn by the
product certification body. A review of the product(s) and compliant standard(s)
will be carried out after 5 years to ensure continued compliance.