User Manual

Chapter 10 Component editor (TXn only)
Amp Editor Owner’s Manual
178
*1 Select DISABLE if you’ll be making settings via CobraNet using CobraNet Manager, etc. Selecting ENABLE may cause
faulty settings.
*2 The number of usable channels will decrease according to this setting. Refer to the “MY16-CII Owner’s Manual” for details.
• For more information on CobraNet, refer to the Yamaha Pro Audio website.
http://www.yamahaproaudio.com
Section Parameter Range Function
q Setting from this Editor DISABLE, ENABLE
Settings via CobraNet will take priority
if you select DISABLE, and the settings
of Amp Editor will take priority if you
select ENABLE
(*1)
.
w
High Sampling
Mode
Input Format
DOUBLE CHANNEL,
SINGLE
Select the input/output mode used for
the high sampling rate (88.2/96 kHz).
Output Format
e Bundle Number
Input
0–65279
Specifies the input bundle number.
Output Specifies the output bundle number.
r Serial Channel
Rx
OFF, 1–15
Specifies the serial channel for the
receiving side.
Tx
Specifies the serial channel for the
transmitting side.
t Bit Length
BIT OFF
16bit
20bit
24bit
Specifies the bit rate for output. If you
specify [BIT OFF], the output will be
muted.
y Latency
5.33ms
2.67ms
1. 3 3 m s
Sets the delay.
u ADVANCED SETTINGS —
Opens the “Advanced Settings” dialog
box.
Section Parameter Range Function
i
Channel per
Bundle
Input
1, 2, 4, 8
Specifies the number of channels per
input bundle
(*2)
.
Output
Specifies the number of channels per
output bundle
(*2)
.
o Conductor Priority Auto, 0–255
Specifies the priority order for becom-
ing conductor. A setting of 255 is the
highest priority.
NOTE