Owner’s Manual

Other functions and information

Optional settings

You can change the following settings.

* This menu enables you to configure network operation during standby mode. If you dis-

able this setting, the unit will stop the network operation and enter Eco Standby mode to

minimize power consumption. The following functions will be unavailable during Eco

Standby mode. To use these functions, press the [A (Power)] button on the bottom

panel to turn on the power to the unit.

• Turning on the power to the unit from MusicCast CONTROLLER

•AirPlay

• Bluetooth

Setting menu Default To modify the default setting:

Initializing the network settings –

While pressing and holding down the [CONNECT] button on the bottom panel, insert the AC adaptor into the AC

outlet, and then keep holding down the [CONNECT] button for another three seconds.

Three indicators on the front panel will flash simultaneously and the network settings will be initialized. Do not operate the

unit until the indicators turn off.

Enabling/disabling the Network

Standby function*

Enabled

While pressing and holding down the [A] button on the bottom panel, insert the AC adaptor into the AC outlet,

and then keep holding down the [A] button for another three seconds.

The power indicator will flash twice and then turn off, and the Network Standby function will be disabled. Repeating this

operation will alternate between enabling and disabling.

When the Standby function is enabled: The power indicator will flash twice, and then light up steadily.

Enabling/disabling Wi-Fi Enabled

While the unit is in standby mode, press and hold down the [OPTION] button on the bottom panel for five seconds.

The front indicators will flash alternately.

2 Press and hold down the [A] button for three seconds.

The Wi-Fi indicator will flash twice, and then turn off, and the Wi-Fi function will be disabled. If you connect the unit to the

Wi-Fi network again, the Wi-Fi function will be enabled ( P. 6 ).

Enabling/disabling Bluetooth Enabled

While the unit is in standby mode, press and hold down the [OPTION] button on the bottom panel for five seconds.

The front indicators will flash alternately.

2 Press and hold down the [CONNECT] button for three seconds.

The Bluetooth indicator will flash twice, and then turn off, and the Bluetooth function will be disabled. Repeating steps 1 and

2 will alternate between enabling and disabling.

When the Bluetooth function is enabled: The Bluetooth indicator will flash twice, and then light up steadily.

With an advanced energy saving design, this product achieves a low

power consumption of not more than two watts when in Network

Standby mode.