User Manual

6 En
NOTICE
Indicates points that you must observe in order to
prevent product failure, damage or malfunction and
data loss.
Power supply/power cord
• If not using the unit for a long period of time, be sure to pull
the power plug from the outlet. Even if the Standby/On
switch has been turned off (the power light is off), a minute
current is still flowing.
Installation
• Do not use this unit in the vicinity of other electronic
equipment, such as a TV, radio, or mobile phone. Failure to
observe this may cause this unit or the TV or radio to
produce noise.
• Do not use this unit in a location that is exposed to direct
sunlight that becomes extremely hot, such as near a
heater, or extremely cold, or that is subject to excessive
dust or vibration. Failure to observe this may cause the
unit’s panel to become deformed, the internal components
to malfunction, or for operation to become unstable.
• The rubber feet supplied with this unit are for preventing
slippage. Use them if installing the unit on a shelf or a table
where it might slip.
• Install this unit as far away from other electronic equipment
as possible.
Digital signals from this unit may interfere with other
electronic equipment.
Connections
• If connecting external units, be sure to thoroughly read the
manual for each unit and connect them in accordance with
the instructions.
Failure to properly handle a unit in accordance with the
instructions could cause malfunctions.
Handling
• Do not place vinyl, plastic, or rubber products on this unit.
Failure to observe this may cause discoloration or
deformation in the panel of this unit.
If the ambient temperature changes drastically (such as
during unit transportation or under rapid heating or
cooling) and there is a chance condensation may have
formed in the unit, leave the unit for several hours without
turning on the power until it is completely dry before use.
Using the unit while there is condensation can cause
malfunctions.
Maintenance
• When cleaning the unit, use a dry, soft cloth. Using
chemicals such as benzine or thinner, cleaning agents, or
chemical scrubbing cloths can cause discoloration or
deformation.
Information
About content in this manual
• The illustrations and screens in this manual are for
instructional purposes only.
• The company names and product names in this manual
are the trademarks or registered trademarks of their
respective companies.
• Software may be revised and updated without prior notice.