User Manual

Keyboard Arp & Drum Pad Owner’s Manual 8
1 Lets you copy all the Pad data from Pad to Pad. Open the Pad Edit window of
the copy source, then tap [COPY]. Next, open the Pad Edit window of the copy
destination, then tap [PASTE] to execute the Copy operation.
2 Clears all note assignments.
3 Play: Tapping the Pad transmits the assigned MIDI note messages once.
Seq: Tapping the Pad starts playback of the Step Sequencer, which transmits
the assigned MIDI note messages.
4 L: The Note message is transmitted only when you tap the left half section of
the Pad.
All: The Note message is transmitted when you tap any location of the Pad.
R: The Note message is transmitted only when you tap the right half section of
the Pad.
5 Determines the MIDI Transmit Channel.
Basic: The value specified via the Pad Basic Tx Ch of Utility is set as the MIDI
Transmit Channel.
Arp: Arpeggio playback is transmitted when ARP ON/OFF is turned ON in the
Keyboard display. In this case, the value specified via the Keyboard Tx Ch of
Utility is set as the MIDI Transmit Channel.
6 To set the Note, tap the desired key in the on-screen keyboard.
7 To set the Velocity, tap the Velocity value or values to call up the slider then
adjust the slider.
8 Clears the note assignment.
9 Tapping here calls up the on-screen keyboard which lets you edit the Pad name.
) Finalizes the settings then closes the window.
! Determines the Note length of the Step Sequencer.
@ Turns on and off each measure (1 – 4) of the Step Sequencer.
# Pinching in and out horizontally adjusts the Gate Time of all the notes.
$ Dragging each bar vertically adjusts the Velocity.
Pad Edit window
From this window, you can set the MIDI notes assigned to the Pad. Select “Play” or “Seq” (3), then make the settings.
Pad Edit window with “Play” Pad Edit window with “Seq”
Velocity
A measure length
Gate time
1
2
3
4
5
6 7
8
9
)
! @
$