User Manual

Voice mode
Song mode
Pattern mode
Mixing mode
Master mode
Utility mode
File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
File Management (File mode)
MOTIF XF Reference Manual
245
8 Select the destination memory type (7) of the
instrument.
When “USR” is selected, the specified Waveform will be
loaded to SDRAM. When “FL1” or “FL2” is selected, the
specified Waveform will be loaded to either slot 1 or 2 of
the optional Flash Memory Expansion Board. When
“FL1 without image” or “FL2 without image” is selected,
only the parameter settings of the specified Waveform
will be loaded to either slot 1 or 2 of the optional Flash
Memory Expansion Board.
9 Press the [SF2] button (a prompt for
confirmation appears).
Press the [DEC/NO] button to cancel the Load
operation.
10 Press the [INC/YES] button to execute the
Load operation.
NOTICE
The Load operation overwrites any data previously existing
in the destination internal memory. Important data should
always be saved to a USB storage device connected to the
USB TO DEVICE terminal or to a computer connected to the
same network as the MOTIF XF (page 241).
This method is available only when entering the File mode
from the Performance mode.
1 Select a device and directory as source by
following “Basic Procedure in the File mode”
on page 238.
2 Set the Type to “performance.”
Only available files according to the Type are listed in
the Directory/File list box on the display.
n In this step, the Load menu corresponding to the [SF2]
button is not shown in the display. The Load menu
appears when selecting a Performance to be loaded in
step 6.
3 Specify the destination memory location in the
User memory.
Select a Performance Bank and number.
n When the Performance number is set to “all,” all the
Performances in the selected Bank will be loaded.
4 Select the file to be loaded.
You can select any of the files listed in the Directory/File
list box on the display.
5 Press the [ENTER] button so that the
Performances in the selected Bank are listed
on the display.
You can change the Performance Bank as source by
pressing the Bank buttons on the front panel.
6 Move the cursor to the desired Performance.
The Load menu corresponding to the [SF2] button
appears.
7 Press the [SF2] button (a prompt for
confirmation appears).
Press the [DEC/NO] button to cancel the Load
operation.
8 Press the [INC/YES] button to execute the Load
operation.
NOTICE
The Load operation overwrites any data previously existing in
the destination internal memory. Important data should always
be saved to a USB storage device connected to the USB TO
DEVICE terminal or to a computer connected to the same
network as the MOTIF XF (page 241).
Loading a specific Performance from
an “all” file
Performances