Owner`s manual

6-55
1
2
3
4
5
6
7
8
9
EAU1722A
PERIODIC MAINTENANCE AND ADJUSTMENT
6-20
place it in a cool, dry place. NO-
TICE: When removing the battery,
be sure the key is turned to
“OFF”, then disconnect the
negative lead before disconnect-
ing the positive lead.[ECA16302]
2. If the battery will be stored for more
than two months, check it at least
once a month and fully charge it if
necessary.
3. Fully charge the battery before in-
stallation.
4. Before installation, make sure that
the battery leads are properly con-
nected to the battery terminals.
ECAT1053
NOTICE
88
88
8 Always keep the battery charged.
Storing a discharged battery can
cause permanent battery dam-
age.
88
88
8 After installing the battery, be
sure to turn the main switch from
“ON” to “OFF” three times in 3
seconds intervals to initialize the
idle speed control system.
Fuse, replacing<IXE>
EAUT2023
Replacing the fuse
ZAUM00**
1
1. Fuse
The fuse holder is located beside the
battery. Remove panel C to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to “OFF” and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not use
a fuse of a higher amperage rat-
ing than recommended to avoid
causing extensive damage to the
electrical system and possibly a
fire.[EWA15131]
NOTICE: After removing and in-
stalling the main fuse, be sure to
turn the main switch from “ON”
to “OFF” three times in 3 seconds
intervals to initialize the idle
speed control system.[ECAT1062]
Specified fuse:
15 A
3. Turn the key to “ON” and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows again,
have a Yamaha dealer check the
electrical system.