Service manual

CHECKING AND CHARGING THE BATTERY/
CHECKING THE FUSE
CHK
ADJ
<&
6.
7.
Install:
8battery
Connect:
8battery leads
(to the battery terminals)
cC
First, connect the positive battery lead
1, and then the negative battery lead 2.
8 After installing the battery, be sure to
turn the main switch from “ON” to “OFF”
three times in 3 seconds intervals to ini-
tialize the idle speed control system.
8. Check:
8 battery terminals
Dirt -» Clean with a wire brush.
Loose connection -» Connect properly.
9. Lubricate:
8 battery terminals
Recommended lubricant
Dielectric grease
10.Install:
8battery cover
Refer to”SIDE COVERS AND TAIL/
BRAKE LIGHT”.
EAS00181
CHECKING THE FUSE
The following procedure applies to all of the fuse.
cC
To avoid a short circuit, always set the main
switch to “OFF” when checking or replacing
a fuse.
1. Remove:
8battery cover
Refer to”SIDE COVERS AND TAIL/
BRAKE LIGHT”.
3-56