Service manual

FRONT FORK
® <?
y
\J$^
(gfm;
^®
\ ^
EAS00658
ASSEMBLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
NOTE:
8 When assembling the front fork leg, be sure
to replace the following parts:
- oil seal
- dust seal
8 Before assembling the front fork leg, make
sure all of the components are clean.
1. Install:
8damper rod assembly1
8rebound spring 2
cC
Allow the damper rod assembly to slide
slowly down the inner tube3 until it
protrudes from the bottom of the inner tube.
Be careful not to damage the inner tube.
2. Lubricate:
8inner tube’s outer surface
Recommended lubricant
Fork oil 10W or equivalent
3. Tighten:
8 Copper washer New
8 damper rod assembly bolt (T)
XI 23 Nm (2.3 m * kg, 16.6 ft * lb)
NOTE:
While holding the damper rod assembly with the
damper rod holder 2 and T-handle 3, tighten
the damper rod assembly bolt.
Damper rod holder
90890-01294(YM-01300-1)
T-handle
90890-01326(YM-01326)
4-24