Service manual

SPECIAL TOOLS
EAS00027
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
NOTE:
8 For U.S.A. and Canada, use part number starting with “YM-”, “YU-”, or “ACC-”.
8 For others, use part number starting with “90890-”.
Tool NO.
Tool name / Function Illustration
90890-01052
90890-01085
YU-01083-2
90890-01084
YU-01083-3
90890-01235
YU-01235
90890-01268
YU-01268
90890-01304
YU-01304
90890-01337
YM-33285
YM-33285-6
90890-01325
YU-24460-01
90890-01352
YU-33984
90890-01367
YM-A9409-7
90890-01400
YM-A9409-3
Meter gear bush tool
This tool is used when removing or install-
ing the meter gear.
Slide hammer bolt(8mm)1
Weight2
These tools are needed to remove the cam-
shaft.
^2
Rotor holding tool
This tool is used to hold the primary fixed
sheave and secondary sheave assembly.
Ring nut wrench
This tool is used to loosen and tighten the
exhaust and steering ring nut.
Piston pin puller set
This tool is used to remove the piston pin.
Clutch spring holder
These tool are used for removing the nut with
holding the compression spring.
Radiator cap tester1
Radiator cap tester adapter2
This tester and its adapter are needed for
checking the cooling system.
1
2
Fork seal driver weight1
Fork seal driver attachment2
This tool is used when installing the fork
seal.
1
2
1-8