Service manual

BELT DRIVE
Clutch shoe thickness
3.7mm(0.146in)
<Limit>:2.0mm(0.079in)
NOTE:
8 Inspect clutch shoesa.
8 After removing the clutch shoe spring, do
not use them again.
8 Replace the all three as a set.
j^ia
\1J
EAS00320
CHECKING THE V-BELT
1. Check:
• V-belt®
Cracks/damage/wear -» Replace.
Grease/oil -» Clean the primary and sec-
ondary sheave.
2. Measure:
• V-belt width a
Out of specification -» Replace.
V-belt width
17.9 mm (0.705 in)
<Limit>: 16.1 mm (0.634 in)
CHECKING THE PRIMARY SHEAVE
1. Check:
• primary sliding sheave©
• primary fixed sheave®
Cracks/damage/wear -» Replace the pri-
mary sliding sheave, primary fixed
sheave and V-belt.
2. Check:
•free movement
Stick or excessive play -» Replace the
primary sliding sheave or collar.
NOTE:
Insert the collar® into the primary sliding
sheave®, and check for free movement.
5-46