Service manual

BELT DRIVE
ENG
EAS00321
CHECKING THE PRIMARY SHEAVE WEIGHTS
The following procedure applies to all of the pri-
mary sheave weights.
1. Check:
• primary sheave weight
Cracks/damage/wear -* Replace.
2. Measure:
• primary sheave weight outside diameter
a
Out of specification -* Replace.
Primary sheave weight outside di-
ameter
15 mm (0.591 in)
<Limit>: 14.5 mm (0.571 in)
CHECKING THE SLIDER
1. Check:
• slider©
Damage/wear^ Replace
EAS00322
CHECKING THE SECONDARY SHEAVE
1. Check:
•secondary fixed sheave
•secondary sliding sheave
Cracks/damage/wear -* Replace the sec-
ondary fixed and sliding sheaves as a
set.
2. Check:
•torque cam groove ©
Damage/wear -* Replace the secondary
fixed and sliding sheaves as a set.
3. Check:
•guide pin (2)
Damage/wear -* Replace the secondary
fixed and sliding sheaves as a set.
5-47