Service manual

CHECKING THE BULBS AND BULB SOCKETS
EAS00733
CHECKING THE BULBS AND BULB
SOCKETS
Check each bulb and bulb socket for damage or
wear, proper connections, and also for continu-
ity between the terminals.
Damage/wear -» Repair or replace the
bulb, bulb socket or both.
Improperly connected -» Properly con-
nect.
No continuity -»Repair or replace the bulb,
bulb socket or both.
TYPES OF BULBS
The bulbs used on this scooter are shown in the
illustration on the left.
8Bulbs A and B are used for the head-
lights and usually use a bulb holder that
must be detached before removing the
bulb. The majority of these types of bulbs
can be removed from their respective
socket by turning them counterclockwise.
8Bulbs C is used for turn signal and tail/
brake lights and can be removed from the
socket by pushing and turning the bulb
counterclockwise.
8Bulbs D and E are used for meter and
indicator lights and can be removed from
their respective socket by carefully pull-
ing them out.
8-6