Service manual

IGNITION SYSTEM
ELEC
+i
EAS00750
• Check the engine stop switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the engine stop switch OK?
YES
V
4
NO
Replace the right
handlebar switch.
EAS00752
10. Sidestand switch(optional)
• Check the sidestand switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the sidestand switch OK?
V
YES NO
Replace the sidestand
switch.
11. Lean angle cut-off switch
• Remove the lean angle cut-off switch.
• Connect the pocket tester(£2 x1) to the lean
angle cut-off switch terminals as shown.
Positive tester probe -> blue ©
Negative tester probe -> yellow/green
/\
x
<•////,
X
m
Lean angle cut-off switch voltage
Less than 65°®-» 0.4~1.4V
More than 65° © -»3.7~4.4V
YES
V
*
NO
Replace the lean angle
cut-off switch.
EAS00754
12. Wiring
• Check the entire ignition system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
• Is the ignition system’s wiring properly con-
nected and without defects?
YES
V
I
NO
Replace the ECU.
Properly connect or re-
pair the ignition system’s
wiring.
8-13
9. Engine stop switch