manual
MOTIF XF Owner’s Manual
69
Troubleshooting
When the Element to which “Key Off Sound” of the XA Control parameter is assigned does not sound, are you releasing the
note after the AEG decays?
The “Key Off Sound” Element will take over the AEG level of the previous Element if both the Elements belong to the same
Element Group. To solve such a problem, release the note before the AEG level decays to minimum or set the “Key Off
Sound” Element to a different Element Group from the previous Elements.
When the Element to which “AF1 on,” “AF2 on,” or “all AF off” of the XA Control parameter is assigned does not sound, is the
corresponding ASSIGNABLE FUNCTION button pressed?
Is “Vocoder” selected as the Insertion Effect Type of the Voice?
If so, set the parameters related to the AD Part and A/D INPUT connector to the appropriate values then play the keyboard
while inputting your voice into the microphone connected to the MOTIF XF. Check whether or not the Gain Knob on the rear
panel is set to the minimum position. For details, see page 47.
When playing the keyboard in the Performance/Song/Pattern mode produces no sound, has a Voice been properly assigned
to each Part?
When Song/Pattern playback produces no sound, are the output channel of each track in the play mode and the receive
channel of each Part in the Mixing mode set appropriately?
When Song/Pattern playback produces no sound, are the Velocity Rate and Velocity Offset settings of the Play FX
appropriate?
No sound is produced when the ARP Play Only parameter is set to on and one of the following situations occurs.
• When the [ARPEGGIO ON/OFF] button is turned off.
• When the ARP Switch parameter of the corresponding Part is set to off.
• When no Arpeggio Type is assigned to the current Voice.
Playback continues without stopping.
When the [ARPEGGIO ON/OFF] button is turned on, press it so that its lamp is turned off.
When in the Song mode or Pattern mode, press the [] (Stop) button.
When the click sound continues, check the following parameter setting. Set this parameter to something other than “always”
because this setting always plays back the click sound regardless of the sequencer status.
Distorted sound.
Are the effect settings appropriate?
Use of an effect at certain settings may produce distortion.
Use of the Master Effect at certain settings may produce distortion.
[VOICE] [EDIT] Element selection [F1] Oscillator Element Group
[VOICE] [EDIT] [COMMON EDIT] [F6] Effect [SF1] Connect INSERTION CONNECT
[VOICE] [UTILITY] [F4] Voice Audio [SF1] Output Output Select = InsL
[VOICE] [UTILITY] [F2] I/O Input Mic/Line = mic
[PERFORM] [F2] Voice
[SONG]/[PATTERN] [MIXING] [F1] Part 1-16
[SONG] [F3] Track [SF1] Out
[PATTERN] [F3] Track
[SONG]/[PATTERN] [MIXING] [EDIT] Part selection [F1] Voice [SF1] Voice Receive Channel
[SONG]/[PATTERN] [F2] Play FX Velocity Offset
[PERFORM]/[SONG]/[PATTERN] [SEQ SETUP] [F1] Click Mode
[VOICE] [EDIT] [COMMON EDIT] [F6] Effect
[PERFORM] [EDIT] [COMMON EDIT] [F5] Effect
[SONG]/[PATTERN] [MIXING] [F5] Effect
[VOICE] [UTILITY] [F3] Voice [SF1] Master FX
[PERFORM] [EDIT] [COMMON EDIT] [F2] Level/MEF [SF2] Master FX
[SONG]/[PATTERN] [MIXING] [EDIT] [COMMON EDIT] [F2] Master FX [SF2] Master FX