Operator`s manual
4-8
E
EJU00536
PERIODIC INSPECTION CHART
Frequency of maintenance operations may be adjusted according to the operating
conditions, but the following table gives general guidelines.
The mark (●) indicates the checkups which you may do yourself.
The mark (1) indicates work to be done by your Yamaha dealer.
Maintenance interval
Item
Spark plug
Inspection/Cleaning
●●●● 4-13
Adjustment
Greasing points Greasing ●● 4-14
Bearing housing Greasing 1*1 ●*2 ●*2 4-16
Starter motor idle gear Greasing 1*3 ●*4 ●*4 –
Fuel system Inspection 11 4-9
Fuel filter Checking/Replacement 114-10
Fuel tank Cleaning 1 4-10
Oil injection system Inspection/Cleaning 114-11
Carburetor setting Inspection/Adjustment 1114-19
Trolling speed Adjustment ●● 4-19
Carburetor throttle shaft Inspection 11 –
● (after
Cooling-water passages Cleaning/Flushing every 4-1
ride)
Bilge strainer Cleaning ●●● –
Impeller Inspection ●●● –
Steering cable Inspection ●● –
Throttle cable and choke cable Inspection/Adjustment ●●
4-12, 4-16
Drain plugs Inspection/Replacement ● 3-5
●
(Inspect
Battery Inspection
fluid level
4-17
before
every ride)
Rubber coupling Inspection 1 –
Bolts and nuts Retightening 111 –
10 50 100 100 200
hours hours hours hours hours
36612
months months months months
Initial
Thereafter
Page
every
*1: Grease capacity: 33.0~35.0 cm
3
(1.11~1.18 oz.)
*2: Grease capacity: 6.0~8.0 cm
3
(0.20~0.27 oz.)
*3: Grease capacity: 8.0cm
3
(0.27 oz.)
*4: Grease capacity: 2.0cm
3
(0.07 oz.)