Operator`s manual

4-14
E
NOTE:
Before installing the spark plug cap, be
sure to wipe off any water on the spark
plug or inside the cap. Push the spark
plug cap down until it clicks.
NOTE:
If a torque-wrench is not available when
you are fitting a spark-plug, a good esti-
mate of the correct torque (with a new
gasket) is 1/4 to 1/2 a turn past finger-
tight. Have the spark-plug adjusted to the
correct torque as soon as possible with a
torque wrench.
w
When removing or installing a spark plug,
be careful not to damage the insulator. A
damaged insulator could allow external
sparks, which could lead to explosion or
fire.
GU21025
GU2104
q
EJU00553
GREASING POINTS
To keep moving parts sliding or rotating
smoothly, coat them with water resistant
grease (Yamaha Marine Grease,
YAMAHA grease A) or equivalent.
Throttle cable and choke cable
1) Grease the carburetor throttle cable
and choke cable inner wires.
2) Pull the throttle lever and remove the
seal. Spray a rust-inhibitor into the
outer cable. Refit the seal securely.
1 Seal