Operator`s manual

2-10
E
EJU00709
COOLING WATER PILOT OUTLET
This engine is equipped with a cooling-water
pilot outlet at both sides of the deck. Check
that water comes out of the outlet while the
engine is running. If you do not see any
water at the outlet, cooling water may not be
circulating in the engine.
In that case, stop the engine and check for
the cause (Refer to overheat warning sys-
tem).
N
O
TE:
If water cooling passages on the engine are
dry it will take about 20 seconds to reach
water at the outlet after starting.
EJU00356a
STEERING
Your water vehicle can be steered by turning
the handlebar 1 the same direction you
wish to travel, to the right or left. When the
handlebar is turned, the angle of the jet (out-
put) nozzle at the stern is changed, and the
change in direction of the nozzle changes
the direction of the vehicle accordingly.
Therefore, because only the strength of the
jet-flow output can determine the speed and
direction of a turn, the throttle must always
be opened above idle when attempting a
turn, except at trolling speed.