Operator`s manual

2-20
E
3) Select your 4-letter code by pressing the
“A/SET”, “B” or “C” buttons in a desired
sequence.
N
O
TE:
If you do not press a button for more than 10
seconds, the display automatically turns off.
This cancels the process of setting of a
code.
4) After completing code setting, the
buzzer will sound 3 times and the dis-
play will show “SET”. Lastly, the display
turns off and the warning lamp (LED)
turns on again. After the meter has dis-
played this sequence, reconnect the
blue connector.
N
O
TE:
●
Your own code is kept even if the battery
terminal is disconnected.
●
If you forget your own code, or if you want
to change the code, do this “Initial setting”
procedure again from the beginning.
● Selecting “START” or “LOCK” mode
Selecting the desired mode can only be
done after the “Initial setting” has been done
and while the display is not lighting.
1) Press the “MODE” button until the meter
displays the current mode, “START” or
“LOCK”.
2) With “START” or “LOCK” displayed,
press the “MODE” button continuously
for about 3 seconds until the display
changes to “COdE”.