Operator`s manual

3-5
E
EJU00726
Water separator
1) Check the water separator 1 to see if
there is any water in the separator.
The water separator retains any water
entering through the fuel tank breather
pipe if the vehicle is capsized.
Normally, this water separator is empty
(no water).
2) If water remains in the water separator,
drain it by loosening the drain plug 2.
Do not forget to tighten the drain plug.
EJU00727
Bilge
Excessive water in the engine compartment
bilge can splash into the carburetor and
engine. This could cause engine damage. If
there is any moisture in the bilge, raise the
bow of the vehicle slightly and remove the
hull drain plugs. After the water has drained,
wipe the bilge with dry rags. Reinstall the
drain plugs securely.
EWJ00054
WARNING
Always properly dispose of gasoline
(petrol) soaked rags. They can spontane-
ously ignite.
ECJ00062
CAUTION
:
Tighten two hull drain plugs securely
before launching the vehicle. Clean any
foreign material, such as dirt or sand,
from the threads before reinstalling the
drain plugs.