Operator`s manual

3-9
E
EJU00452a
Switches
First, place the vehicle in the water to pro-
vide adequate engine cooling. Push the
starter switch 1 and start the engine, then
push the engine stop switch 2. Restart the
engine and pull the lanyard on your left wrist
to remove the lock-plate 3 from the engine
stop lanyard switch. Verify that the engine
stops immediately, when the engine stop
switch pushed or the lock-plate remove from
the engine stop lanyard switch. Be sure the
lanyard is in good condition with no frayed or
broken parts. A damaged lanyard must be
replaced; it should never be repaired or tied
together.
EJU00453a
Cooling water pilot outlet
Check that cooling water comes out from the
outlet(s) while engine is running in the water.
EJU00454a
Multifunction meter
Check the proper operation of multifunction
meter. Refer to “MULTIFUNCTION METER”
in Chapter 2 for correct meter operation.