User Manual
Table Of Contents
- Cover
- What is Amp Editor?
- Special Notices
- Contents
- Preparing for operation
- An overview of Amp Editor
- Setup
- Basic operations in Amp Editor
- Main panel window
- Objects in the window and their function
- Menus in the main panel window
- Preferences
- Event Log
- Device Information
- Scene Manager
- Alert Setup
- Word Clock (TXn only)
- Speaker Processor Library Manager (TXn only)
- Clock
- Language (TXn only)
- GPI (ACD1 only)
- Utility
- IP Address
- IP Control Port No.
- Firmware Update (Updating the internal firmware)
- Scene Link Manager (for devices other than XMV)
- Network Setup
- Synchronization (Synchronization with devices)
- Custom Control Panel Manager
- System View Creator
- Speaker Processor Library Converter
- Tree View window
- Detail View window
- Device Properties window
- Signal Path View window (TXn only)
- Component editor (TXn only)
- Custom control panels
- Appendix
Chapter 8 Device Properties window
Amp Editor Owner’s Manual
133
[Limiter] tab (TXn only)
Here you can specify the limiter values for each amplifier.
These settings can be changed when online or offline.
q Voltage Limiter
These settings specify how the limiter will be controlled by the output voltage.
Check box
Turns the limiter on/off.
Threshold
Specifies the upper threshold value for the output voltage.
Click the [ APPLY] button to specify the value calculated in the “Calculate the Output Voltage.”
Attack
Specifies the time over which 20 dB of attenuation will be applied after the threshold value is exceeded.
Release
Specifies the time over which the voltage that had been attenuated will be returned to the original level
after the voltage falls back to below the threshold value.
q
w
e
r
t