User Manual

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

140

y Notch Filter

Enables/disables the notch filter that eliminates the frequency component of the pilot tone to prevent the pilot

tone from being output by the amplifier. The center frequency of the notch filter is the value specified in Fre-

quency (q).

 Check box

Enables/disables the notch filter.

 Q

Specifies the width of the notch filter’s frequency band.

 [Output Signal Chain Check] tab (TXn only)

Here you can make settings for using the pilot tone to determine whether the output might be disconnected or

shorted. By outputting a pilot tone, the impedance can be detected reliably without relying on the audio signal

output.

These settings can be changed when online or offline.

• If an HF driver is installed in the connected speaker, do not select Low Frequency. The driver

might be damaged due to the low-frequency component since the pilot tone is added after the

Speaker Processor.

The same settings can be made for Channel A and Channel B.

CAUTION