User Manual

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

132

 [General] tab (XMV)

Here you can confirm the DIP switch settings and specify each channel’s frequencies. You can change these set-

tings only when online.

q Output Setup

This section displays the [SPEAKERS] DIP switch settings on the XMV’s rear panel.

• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have

been set to something other than the specified combination. For more information on the [SPEAK-

ERS] DIP switches, refer to the XMV Owner’s Manual.

w HPF

This section enables you to specify the HPF frequencies. You can select 40Hz/80Hz for high impedance, and

Off, 40Hz or 80Hz for low impedance.

• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have

been set to something other than the specified combination.

NOTE