User Manual

Table Of Contents

Dante Controller User Guide

-19-

Example: The power supply on “stage-box” fails and “stage-box” needs to be replaced. The

old “stage-box” is removed, and a new box is plugged in and named “stage-box”. Dante

receivers previously subscribed to the old “stage-box” will now automatically restore their

subscriptions to the new “stage-box”.

n Device names must be unique on the network. If you attempt to rename a device using Dante Con-

troller to a name that is already in use on the network, Dante Controller will notify you and reject the

name change.

Example: There is an existing device on the network called “MY16-slot1”. If user attempts to

rename another device to “MY16-slot1” Dante Controller will notify you that the name is already

in use. The device will not be renamed.

n If a new device is added to the network with a name that already exists, a name conflict is detected,

and one of the devices will rename itself by appending (2) to its name. This device will not be able to

transmit audio until it is renamed.

Note: A device that has been renamed with (2) appended (e.g. “MY16-slot1(2)”) will not be able to

transmit audio until it is renamed. The device name must be changed by the user to be a valid non-

conflicting name before the device can become fully functional.

Rules for Names and Labels

n All Dante names and labels are up to 31 characters in length. Name and label comparisons are case-

insensitive; “Guitar” and “guitar” are treated as the same label. Unicode and non-roman char-

acters are not supported.

n Device names should follow Domain Name System (DNS) hostname rules. Legal characters are A-

Z, a-z, 0-9, and '-' (dash or hyphen).

n Tx channel labels may use any character except '=' (equals), '.' (full stop or period), or '@' (at). Tx

channel labels must be unique on a device. Tx channel labels do not need to be unique on the net-

work as they are always qualified by device (channel@device).

n Rx channel labels follow the same rules as Tx channel labels.

Routing Audio

Routing Terminology

n Device: A device means a Dante-enabled device, and more specifically that component of the audio

equipment that implements the Dante interface. A Dante device typically has Tx and Rx channels

and other routing-related properties.

n Transmit (Tx) channel: A transmit channel transmits audio from the audio hardware onto the net-

work.

n Receive (Rx) channel: A receive channel receives audio from the network and sends it to the audio

hardware.

n Flow: Dante audio routing creates flows. Each flow carries several channels of audio from a trans-

mitter to one or more receivers. Unicast routing creates flows to single receivers. Multicast routing

creates flows that can be received by multiple receivers. Multicast flows are assigned IDs enabling

them to be identified in Dante Controller.