User Manual

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

139

 [Input Signal Chain Check] tab (TXn only)

Here you can make settings to specify how a pilot tone supplied from the external device will be detected to

determine whether the input has been interrupted. These settings can be changed when online or offline.

The settings for Analog Input and Slot Input are the same.

q Frequency

Specifies the center frequency of the pilot tone.

w [Monitoring the Pilot Tone] check box

Enables/disables monitoring of whether the input has been interrupted. If this is checked, the Signal Chain

Check warning indicator will light red if a pilot tone above the specified Detection Threshold level could not

be detected within the specified Detection Time.

e Detection Threshold

Specifies the threshold value for the pilot tone input level.

r Detected Level

Indicates the input level of the pilot tone currently being received.

t Detection Interval Time

Specifies the detection time for the pilot tone.

If the pilot tone was not detected within the specified time interval, it will be determined that the input has

been interrupted.