User Manual
Chapter 3 Setup
Amp Editor Owner’s Manual
20
Setting the device IP address (example for a TXn or ACD1)
On a TXn or ACD1, the Auto IP Address Assignment function of Amp Editor (page 92) automatically assigns an
IP address to each device. The following procedure is based on the assumption that these IP address settings are
used for communication between the devices and Amp Editor.
1. Before turning on the power to the devices, use an Ethernet cable to connect your com-
puter’s Ethernet connector to the network switch, and then start up the computer.
2. Click [Start] [All Programs] [Yamaha Amp Editor] [Amp Editor] to start Amp Edi-
tor.
3. From the Amp Editor menu bar, choose [System] [Network Setup].
The “Network Setup” dialog box will appear.
4. In [Network Interface], select the network adapter you’re using.
As the network adapter, select the same card as you used in “Computer’s IP address setting.”
5. If necessary, click the [Change Range] button to edit the range of the IP address to be
assigned to the device.
6. If the [Enable] checkbox in the Auto IP Address Assignment section is not checked,
check it to enable the Auto IP Address Assignment function.