User Manual

Chapter 5 Main panel window

Amp Editor Owner’s Manual

Network Setup

Click the [System] menu command [Network Setup...] to access the “Network Setup” dialog box. This dialog

box contains the following three functions.

 Network Interface

Selects the network interface card for communication.

This can be selected only when offline.

 Auto IP Address Assignment

While Amp Editor is running, it will operate as a DHCP server and will assign the range of IP addresses to

devices whose “IP Address Mode” is DHCP. This will not operate if a DHCP server exists in the network.

 Amplifier IP Address Mode

The “IP Address Mode” of all devices connected to the specified network will be switched to DHCP or

Manual.

• If you want to specify IP addresses one unit at a time, use the “IP Address” dialog box (page 84).

NOTE