Owner's Manual

Controls and Functions
XMV8280/XMV8140/XMV8280-D/XMV8140-D Owner’s Manual
12
XMV8280/XMV8140
XMV8280-D/XMV8140-D
!9 Network connector (XMV8280/XMV8140 only)
This is a 100BASE-TX Ethernet connector that allows the
unit to be connected to a computer via an Ethernet cable.
@0 [YDIF] connectors (XMV8280/XMV8140 only)
These are RJ-45 connectors that allow the unit to be con-
nected via an Ethernet cable to another YDIF-equipped
device so that audio signals and word clock signals can be
transmitted and received. Using a ring connection (YDIF
connection), you can connect to other devices equipped with
a [YDIF] connector. For details on settings for receiving
audio signals via the [YDIF] connector, refer to “Front Panel
Operations” (page 23).
Cables used for this connection should be 30 meters or less
between devices. Up to eight devices can be connected in a
network with YDIF connection.
For information on connections that use [YDIF] connectors,
refer to the “MTX Setup Manual.”
Rear Panel
1 2 3 4 5 6 7 8
ON
ON ON
@8@7 @9!9 @0 @2
@3
@4 @6
@4 @5
ON ON
1 2 3 4 5 6 7 8
ON
@8@7 @9
@4 @6
@1
@3
@2 @4 @5
NOTE
• Use a CAT5e or better STP (Shielded Twisted Pair) cable
for the network connection to prevent electromagnetic
interference.
• When using MTX Editor to control the XMV, you must con-
nect the MTX.
NOTE
To prevent electromagnetic interference, make connections
to the [YDIF] connector using a CAT5e or better STP
(Shielded Twisted Pair) cable in which all pins are con-
nected with a straight connection.