Operation Manual

PERIODIC MAINTENANCE
3-11
• Footboard (right)
Refer to “GENERAL CHASSIS” on page
4-1.
2. Check:
• Cylinder head breather hose “1”
Cracks/damage → Replace.
Loose connection → Connect properly.
ECA14920
Make sure the cylinder head breather hose
is routed correctly.
3. Install:
• All removed parts
EAS20600
ADJUSTING THE EXHAUST GAS VOLUME
TIP
Be sure to set the CO density level to stan-
dard, and then adjust the exhaust gas volume.
1. Set the main switch to “OFF” and set the
engine stop switch to “ ”.
2. Simultaneously press and hold the left set
“1” and right set “2” buttons, set the main
switch to “ON”, and continue to press the
buttons for 8 seconds or more.
TIP
“dIAG” appears on the odometer LCD.
3. Press the left set button to select the CO
adjustment mode “Co” or the diagnostic
monitoring mode “dIAG”.
4. After selecting “Co”, simultaneously press
the left set and right set buttons for 2 sec-
onds or more to execute the selection.
5. Press the left set and right set buttons to
select a cylinder.
TIP
The selected cylinder number appears on the
clock LCD.
• To decrease the selected cylinder number,
press the right set button.
• To increase the selected cylinder number,
press the left set button.
6. After selecting the cylinder, simultaneously
press the left set and right set buttons for 2
seconds or more to execute the selection.
7. Change the CO adjustment volume by
pressing the left set and right set buttons.
TIP
The CO adjustment volume appears on the
odometer LCD.
• To decrease the CO adjustment volume,
press the right set button.
• To increase the CO adjustment volume,
press the left set button.
8. Release the switch to execute the selec-
tion.
9. Simultaneously press the left set and right
set buttons to return to the cylinder selec-
tion (step 5).
10. Set the main switch to “OFF” to cancel the
mode.
EAS21081
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the
exhaust pipes and gaskets.
1. Remove:
• Side cover (right)
Refer to “GENERAL CHASSIS” on page
4-1.