Operation Manual

PERIODIC MAINTENANCE
3-31
Handling notes for coolant
Coolant is potentially harmful and should
be handled with special care.
WARNING
EWA13040
If coolant splashes in your eyes, thor-
oughly wash them with water and consult
a doctor.
If coolant splashes on your clothes,
quickly wash it away with water and then
with soap and water.
If coolant is swallowed, induce vomiting
and get immediate medical attention.
ECA13480
Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant check,
and if necessary, correct the antifreeze
concentration of the coolant.
Use only distilled water. However, if dis-
tilled water is not available, soft water
may be used.
If coolant comes into contact with painted
surfaces, immediately wash them with
water.
Do not mix different types of antifreeze.
10. Install:
Radiator cap
11. Fill:
Coolant reservoir
(with the recommended coolant to the
maximum level mark “a”)
12. Install:
Coolant reservoir cap
13. Start the engine, warm it up for several
minutes, and then stop it.
14. Check:
Coolant level
Refer to “CHECKING THE COOLANT
LEVEL” on page 3-29.
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
15. Install:
Footboard (left)
Refer to “GENERAL CHASSIS” on page
4-1.
Side cover (left)
Refer to “GENERAL CHASSIS” on page
4-1.
•Center cover
Refer to “GENERAL CHASSIS” on page
4-1.
EAS4B51007
REPLACING THE V-BELT
1. Remove:
•Center cover
Refer to “GENERAL CHASSIS” on page
4-1.
Side cover (right)
Refer to “GENERAL CHASSIS” on page
4-1.
Footboard (right)
Refer to “GENERAL CHASSIS” on page
4-1.
Outer V-belt case
Refer to “V-BELT AUTOMATIC TRANS-
MISSION” on page 5-39.
Recommended antifreeze
High-quality ethylene glycol anti-
freeze containing corrosion
inhibitors for aluminum engines
Mixing ratio
1:1 (antifreeze:water)
Radiator capacity (including all
routes)
1.50 L (1.59 US qt, 1.32 Imp.qt)
Coolant reservoir capacity (up
to the maximum level mark)
0.27 L (0.29 US qt, 0.24 Imp.qt)