Operation Manual

GENERAL CHASSIS
4-10
EAS59C1427
ADJUSTING THE WINDSHIELD HEIGHT
1. Adjust:
• Windshield height
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the windshield cover and wind-
shield assembly.
Refer to “REMOVING THE WINDSHIELD”
on page 4-9.
b. Remove the rubber caps “1”.
c. Install the rubber caps “1” in the desired
position.
d. Install the windshield assembly to the
desired position by installing the bolts “1”.
e. Tighten the bolts to the specified torque.
f. Installing the windshield cover.
Refer to “INSTALLING THE WINDSHIELD”
on page 4-9.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS59C1409
REMOVING THE FRONT COVER
1. Remove:
• Front cover
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the two metal clips “1” and six
claws “2” from the front cover.
b. Pull the three projections “3” of the front
cover to the front side and remove them.
c. Remove the quick fastener “4”.
d. Remove the two claws “5” from the end of
the front cover.
Windshield bracket bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)