Operation Manual
REAR WHEEL
4-31
EAS22040
REMOVING THE REAR WHEEL (DISC)
ECA59C2410
Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the rear wheel hub “1”, otherwise the
wheel sensor rotor equipped in the wheel
hub may be damaged, resulting in improper
performance of the ABS system.
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there
is no danger of it falling over.
TIP
Place the vehicle on the centerstand so that
the rear wheel is elevated.
2. Remove:
• Rear wheel sensor “1”
• Rear brake caliper “2”
• Rear brake lock caliper “3”
TIP
Do not apply the brake lever when removing
the brake caliper.
3. Loosen:
• Locknuts “1”
• Adjusting bolts “2”
(left side and right side)
4. Remove:
• Wheel axle nut “1”
• Washer
• Rear wheel axle “2”
• Rear wheel
• Rear brake caliper bracket
• Rear wheel sensor housing
• Collars
TIP
Push the rear wheel forward and remove the
drive belt from the rear wheel pulley.
EAS22080
DISASSEMBLING THE REAR WHEEL
ECA59C2406
• Keep magnets (including magnetic pick-
up tools, magnetic screwdrivers, etc.)
away from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or
subject it to shocks.
• If any solvent gets on the wheel sensor
rotor, wipe it off immediately.
1. Remove:
• Rear wheel sensor rotor
•Oil seals
• Wheel bearings
Refer to “DISASSEMBLING THE FRONT
WHEEL” on page 4-20.